In fact, we warn you that in terms of pricing, make your own history it starts to be more expensive than the purchase made, but this is because often the things we need to produce will have very large size than we need to. This means, on the other hand, that over time it will be cheaper because we will have the material to make a few rubies.
Prerequisites
To begin, we will need three things basically: one anti slip baseand rubber fluffy regular, and sthe fabric is more about the design we want put it.
The anti-slip base can be found in almost any store. Best of all, and worth it for the one who is used, for example, to put under the housing jacks so that they don't get out of their place. As you can see, in the example below, we have 200 x 80 inches, so imagine how many mouse pads can get out there.
After that we will need a rubber. There are different things and sizes, so when it comes you have to choose the one you like or like. We suggest these pieces EVA foam which is 2mm thick and we find it suitable for this.
As for the fabric, we leave it to your choice because it will depend on the design you want. The key to this election is to be so A clear, unlit cloth.
Lastly, you will need a scarf and ruler to cut the pieces in size, but also glue. It is not recommended to use glue in art because it goes with the fabric and hardens it, and it is not a special fabric glue because it does not adhere properly to the base. Good choice transparent glue all over.
How to customize a shirt
The first step is to cut the three pieces to the desired size. The amount you cut into pieces does not matter, depending on what you want, but it is important that it is the same for the three pieces so that the mat ends well. However, we can't cut it into three pieces right now and do it once they are glued together. It doesn't matter.
Once cut, we start distribute glue to foam rubber or EVA foam, in a zigzag shape, and then spread the glue through the kitchen paper. This is important so that there are no more marks, preferably using a glue layer.
Once this is done, start by stretching the fabric and running your fingers over the whole surface to be repeated, so that the fabric stretches smoothly and without any edges. As we mentioned earlier, the fabric can be great without a problem because we can cut it easily over time.
It is very important to allow the glue to dry completely before moving on to the next step (about 6 hours). Once this is done, we repeat the process on the other hand to challenge the anti-slip.
Once the glue has spread, we put a piece of cloth in place.
Now we have to wait for it to dry completely (another six hours, though 24 hours is recommended for a good finish), and we can continue the size if we didn't do it at first.
Finally, you should be left to finish the same as shown in the following picture. You should try to have a good drive and help the governor cut and make it perfect.
You've seen it. Making your own custom mat is very straightforward and doesn't require a lot of skills, just selecting materials and some patience. Also, even if you spend 20 euros on the original materials, you have already seen that over time it is worth it because with the purchased item you will be able to do, of course, 10 meters.